Sebring LX Convertible L4-2.4L VIN X (2002)
cylinder block (Fig. 44).
8. To ensure correct thrust bearing alignment, perform the following steps:
^
Step 1: Rotate crankshaft until number 4 piston is at TDC.
^
Step 2: Move crankshaft rearward to limits of travel.
^
Step 3: Then, move crankshaft forward to limits of travel.
^
Step 4: Wedge an appropriate tool between the rear of the cylinder block (NOT BED PLATE) and the rear crankshaft counterweight. This will
hold the crankshaft in its furthest forward position.
^
Step 5: Install and tighten bolts (1 - 10) in sequence shown in (Fig. 44) to 41 Nm (30 ft. lbs.).
^
Step 6: Remove wedge tool used to hold crankshaft.
9. Tighten bolts (1 - 10) again to 41 Nm (30 ft. lbs.) in sequence shown in (Fig. 44).
10. Install main bearing bedplate to engine block bolts (11 - 20), and torque each bolt to 28 Nm (250 in. lbs.) in sequence shown in (Fig. 44).
11. Tighten bolts (1 - 10) to 75 Nm (55 ft. lbs.) in sequence shown in (Fig. 44).
12. Tighten bolts (11 - 20) again to 28 Nm (250 in. lbs.) in sequence shown in (Fig. 44).
13. After the main bearing bedplate is installed, check the crankshaft turning torque. The turning torque should not exceed 5.6 Nm (50 in. lbs.).
14. Check crankshaft end play.
15. Install connecting rod bearings and caps. Do Not Reuse Connecting Rod Bolts. Torque connecting rod bolts to 27 Nm (20 ft. lbs.) plus 1/4 turn.
16. Install balance shafts and housing assembly.
17. Install the oil pump.
18. Install oil pump pick-up tube. Torque fastener to 23 Nm (200 in. lbs.).
19. Install the oil pan.
20. Install crankshaft position sensor.
21. Install cylinder head if it was removed.
22. Install the timing belt rear cover.
23. Install crankshaft sprocket.
24. Install the timing belt.
25. Install the timing belt front covers.
26. Install engine mount support bracket.
27. Install crankshaft vibration damper.
28. Install NEW oil filter.
29. Install crankshaft rear oil seal.
30. Install flex plate. Apply Mopar Lock & Seal Adhesive to bolt threads and tighten to 95 Nm (70 ft. lbs.).
31. Attach transaxle to engine. Tighten attaching bolts to 101 Nm (75 ft. lbs.).
32. Install the engine assembly.
