Sebring LX Convertible L4-2.4L VIN X (2002)
Audible Warning Device: Testing and Inspection
CHIME CONDITIONS
For Removal and Installation of Junction Block (JB) (Refer to POWER DISTRIBUTION/JUNCTION BLOCK - REMOVAL).
For Removal and Installation of Body Control Module (BCM), refer to Electrical, Electronic Control Modules, Body Control Modules, Removal ,
and Installation.
No Tone When Ignition Switch Is Turned ON And Drivers Seat Belt Is Unbuckled And Fully Retracted
1. Check driver's seat belt retractor switch for a ground when belt is retracted.
2. Use DRB III scan tool to perform PCI data bus diagnostics on the BCM for battery, ignition and seat belt switch inputs.
3. Use DRB III scan tool to perform actuator diagnostics on BCM Chime.
4. Check for tone in any other function.
Fig.1 Junction Block Connector To The BCM
5. Remove BCM from Junction Block. Check for battery voltage at terminal JB-12 and ignition feed at terminal JB-6 of BCM (Fig. 1). Refer to the
appropriate wiring information. The wiring information includes wiring diagrams, proper wire and connector repair procedures, details of wire
harness routing and retention, connector pin-out information and location views for the various wire harness connectors, splices and grounds.
6. If voltage not OK, repair as necessary.
No Fasten Seat Belt Lamp When Ignition Switch Is Turned ON
1. At power-up, the cluster will turn ON the seat belt warning indicator for 6 ± 1 seconds as required regardless of the driver side seat belt buckle
status. If the warning indicator does not turn ON, verify if the socketted red LED is seated properly and good contact with the PC-board is present.
If not seated properly, then seat the LED properly by twisting the socket counterclockwise. If seated properly, replace the LED.
Seat Belt Lamp ON For More Than 7 Seconds After Driver Seat Belt Buckle Switch Is Fastened And Ignition ON
1. Use a DRB III scan tool to verify status of the driver seat belt buckle switch as received by the instrument cluster. Compare to the actual seat belt
buckle status: If buckled, lamp is OFF or if unbuckled, lamp is ON. If the status received by the instrument cluster does match the actual buckle
seat belt switch status (buckled/unbuckled), then check the driver seat belt switch and wiring for proper connection.
No Tone Or Door Indicated In Place Of Odometer When A Door Is Ajar And Vehicle Begins Moving
The vehicle must be moving for the chime to occur. However the door indicator will come ON regardless of the vehicle movement. The PCI data bus,
Transmission Control Module (TCM) and Powertrain Control Module (PCM) must be operational.
1. Check all door jamb switches.
2. Use DRB III scan tool to perform PCI data bus diagnostics on BCM for battery and ignition switch input
