Sebring LX Convertible L4-2.4L VIN X (2002)
Air Filter Element: Service and Repair
AIR CLEANER ELEMENT
REMOVAL
1. Disconnect negative battery cable.
2. Disconnect inlet air temperature sensor electrical connector.
3. Disconnect fresh air makeup hose from throttle body air inlet hose.
4. Disconnect PCV hose from intake manifold.
5. Loosen hose clamp at throttle body air inlet hose. Remove hose from throttle body
6. Push in on locking tabs to disengage air inlet hose from air cleaner housing. Remove throttle body air inlet hose and air cleaner element together.
7. Separate air cleaner element from throttle body air inlet hose.
INSTALLATION
1. Clean any debris from inside air cleaner housing.
2. Install air cleaner element onto throttle body air inlet hose.
3. Install throttle body air inlet hose into air cleaner housing. Push in on hose until an audible click" is heard from locking tabs.
4. Install hose on throttle body Tighten hose clamp.
5. Connect PCV hose to intake manifold.
6. Connect fresh air makeup hose.
7. Connect inlet air temperature sensor electrical connector.
8. Connect negative battery cable.
