Sebring LX Convertible L4-2.4L VIN X (2002)
Fig.25 O2 Sensors 2.7L
3. Use a socket such as Snap-On YA8875 or a crow foot wrench to remove oxygen sensor.
INSTALLATION
Downstream 1/2
The O(2)S are located in the side of the catalytic converter.
1. After removing the sensor, the exhaust manifold threads must be cleaned with an 18 mm X 1.5 + 6E tap. If reusing the original sensor, coat the
sensor threads with an anti-seize compound such as Loctite 771-64 or equivalent. New sensors have compound on the threads and do not require
an additional coating.
2. Install the O(2)S. Tighten to 28 N.m (20 ft. lbs.) torque.
3. Connect the O(2)S wire connector.
4. Lower the vehicle.
5. Install the negative battery cable.
Upstream 1/1
The engines uses 1 heated oxygen sensors in the exhaust manifold.
1. After removing the sensor, the exhaust manifold threads must be cleaned with an 18 mm X 1.5 + 6E tap. If reusing the original sensor, coat the
sensor threads with an anti-seize compound such as Loctite 771-64 or equivalent. New sensors have compound on the threads and do not require
an additional coating. Tighten the sensor to 28 N.m (20 ft. lbs.) torque.
2. Connect the heated oxygen sensor electrical connector.
3. Install the negative battery cable.