Sebring LX Convertible L4-2.4L VIN X (2002)
1. Position rear seat belt and retractor assembly to rear seat support assembly.
2. Engage hook on seat belt retractor to slot in rear seat support assembly.
3. Install bolt attaching seat belt retractor to rear seat support assembly. Tighten seat belt fastener to 40 Nm (350 in. lbs.) torque.
4. Route seat belt through channel and snap bezel onto top of channel.
5. Install bolt attaching seat belt anchor to floor pan. Tighten seat belt fastener to 40 Nm (350 in. lbs.) torque.
6. Verify that seat belt is not twisted when engaged to seat belt buckle and that the tab on the lower seat belt anchor is between the formations on the
floor pan.
7. Install quarter trim panel. Refer to Body, Interior, Lower Quarter Trim Panel, Installation.
8. Install rear seat back. Refer to Body, Seats, Rear Seat Back, Installation.
9. Install rear seat cushion. Refer to Body, Seats, Rear Seat Cushion, Installation.
10. Connect the battery negative cable.
