Sebring LX Convertible L4-2.4L VIN X (2002)
Back Window Glass: Procedures
Convertible Top Rear Window
REMOVAL
1. Release folding top latches and allow top cover to relax
2. Lift shower curtain and remove push in nuts holding curtain to the studs.
CAUTION: Take precautions not to tear curtain on the boot shelf during removal.
3. Disengage the headliner at the rear sail panels.
4. Disconnect wire connectors from terminals on heated rear window.
5. Pull wire harness from sleeves at each side of the rear window.
6. Remove nuts attaching belt line tack strips to vehicle.
NOTE: Support top 12 inches above windshield header.
7. Remove the five piece belt line tack strips.
8. Disengage elastic strap from the third roof bow, if equipped.
9. Remove antenna mast.
10. Place protective padding over the entire rear deck area to protect paint. Move tack strips to top of deck opening onto protective padding.
Sail Panel Reference Marks
11. Mark the outer sail panels along the top edges and down the seams between the outer and second tack strips from the outside of top.
NOTE: Reference marks will be used to reinstall the new rear window assembly.
