Sebring LX Coupe V6-3.0L VIN H (2002)
STEP 11. Check the multi-center display connector C-06 for damage.
Q: Is multi-center display connector C-08 in good condition?
YES: Go to Step 12.
NO: Repair or replace it. Refer to Harness Connector Inspection. The multi-center display should work normally.
STEP 12. Check the harness wires between C-08 and ignition switch (IG1).
NOTE: After checking joint connector C-141 and junction block connector C-311 and C-308, check the wires. If joint connector C-141 and junction
block connector C-311 and C-308 are damaged, repair or replace them. Refer to Harness Connector Inspection.
Q: Is the harness wires between C-08 and ignition switch (IG1) in good condition?
YES: There is no action to be taken.
NO: Repair them. The multi-center display should work normally.
Inspection Procedure 2
Compass is not Displayed
