Sebring LX Coupe V6-3.0L VIN H (2002)
STEP 2. Check the compass sensor connector D-01 and compass-ECU connector C-17 by backprobing.
1. Do not disconnect the compass sensor connector D-01 and corn pass-ECU connector C-17, measure at the harness side.
2. Measure the resistance between compass sensor connector D-01 and compass-ECU connector C-17 by backprobing.
Q: Is the resistance value less than 2 ohm?
YES: Go to Step 3.
NO: Repair or replace it. Refer to Harness Connector Inspection.
STEP 3. Check the compass-ECU connector C-16 and multi-center display connector C-08 for damage.
Q: Are the compass-ECU connector C-16 and multi-center display connector C-08 in good condition?
YES: Go to Step 4.
NO: Repair or replace it. Refer to Harness Connector Inspection.
