Sebring LX Coupe V6-3.0L VIN H (2002)
STEP 3. Check the front-ECU connector A-10X for loose, corroded or damaged terminals, or terminals pushed back in the connector.
Q: Is front-ECU connector A-10X in good condition?
YES : Go to Step 4.
NO : Repair or replace the damaged component(s). Refer to Harness Connector Inspection. Confirm the DTC 13 is not displayed. See: Diagrams
STEP 4. Check the wiring harness between front-ECU connector A-10X (terminal 7) and battery.
Q: Is the wiring harness between front-ECU connector A-10X (terminal 7) and battery in good condition?
YES : No action is necessary and testing is complete.
NO : The wiring harness may be damaged or the connector(s) may have loose, corroded or damaged terminals, or terminals pushed back in the
connector. Repair the wiring harness as necessary. Confirm the DTC 13 is not displayed.
STEP 5. Check the ground circuit to the front-ECU. Test at front-ECU connector A-11X.
1. Disconnect the front-ECU connector A-11X and measure the resistance available at the relay box side of the connector.
