Sebring LX Coupe V6-3.0L VIN H (2002)
TECHNICAL DESCRIPTION (COMMENT)
The ETACS-ECU operates the power window timer function, based on input signals from the following switches:
-
Ignition switch (IG1)
-
Driver's or passenger's door switch If the power window timer function do not work normally, the input signal circuit or the ETACS-ECU
may be defective.
TROUBLESHOOTING HINTS
-
The driver's or passenger's door switch may be defective.
-
The ETACS-ECU may be defective.
-
The wiring harness or connectors may have loose, corroded or damaged terminals, or terminals pushed back in the connector.
DIAGNOSIS
Required Special Tools:
-
MB991223: Test Harness Set
-
MB991502: Scan Tool (MUT-II)
-
MB991529: Diagnostic Trouble Code Check Harness
STEP 1. Check method of the input signal.
Q: Which is to be used, the scan tool or a voltmeter to check the input signal?
Scan tool MB991502 : Go to Step 2.
Voltmeter : Go to Step 3.
STEP 2. Check the input signal (by using scan tool MB991502).
Check the input signals from the following switches:
-
Ignition switch (IG1)
-
Driver's and passenger's door switches
CAUTION: To prevent damage to scan tool MB991502, always turn the ignition switch to the "LOCK" (OFF) position before connecting or
disconnecting scan tool MB991502.
1. Connect scan tool MB991502 to the data link connector.
2. Check that the tone alarm of scan tool MB991502 sounds when the input signal enters.
Q: Does the tone alarm of scan tool MB991502 sound when the input signal enters?
YES : Replace the ETACS-ECU. The power window timer function should work normally.
NO :
-
Scan tool MB991502 does not sound when the ignition switch is turned from "ACC" to "ON": Refer to Inspection Procedure O-2 "The
ignition switch (IG1) signal is not sent to the ETACS-ECU."
-
Scan tool MB991502 does not sound when the driver's or passenger's door is opened: Refer to Inspection Procedure O-8 "The driver's or
passenger's door switch signal is not sent to the ETACS-ECU.
STEP 3. Check the input signal (by using a voltmeter).
Check the input signals from the following switches:
-
Ignition switch (IG1)
-
Driver's and passenger's door switches
