Sebring LX Coupe V6-3.0L VIN H (2002)
NO : Scan tool MB991502 does not sound when the sunroof switch is turned from "OFF" to "OPEN/TILT UP" or "CLOSE/TILT DOWN":
Refer to Inspection Procedure O-19 "The open/tilt up or close/tilt down switch signal is not sent to the ETACS-ECU."
Inspection Procedure F-3
INSPECTION PROCEDURE F-3: Sunroof: Sunroof timer function does not work normally.
TECHNICAL DESCRIPTION (COMMENT)
The sunroof motor assembly deactivates the sunroof timer if the SWS communication line is open circuited. In addition, when the doors are opened if the
door switch circuit is defective and the timer is on, the sunroof timer should not operate normally.
TROUBLESHOOTING HINTS
-
The driver's or passenger's door switch may be defective.
-
The sunroof motor assembly may be defective.
-
The wiring harness or connectors may have loose, corroded or damaged terminals, or terminals pushed back in the connector.
DIAGNOSIS
Required Special Tools:
-
MB991223: Test Harness Set
-
MB991502: Scan Tool (MUT-II)
-
MB991529: Diagnostic Trouble Code Check Harness
STEP 1. Check method of the in put signal.
Q: Which is to be used, the scan tool or a voltmeter to check the input signal?
Scan tool MB991502: Go to Step 2.
Voltmeter: Go to Step 3.
STEP 2. Check the input signal (by using the scan tool MB991502).
Check the input signals from the following switches:
-
Ignition switch (IG1)
-
Driver's and passenger's door switch
-
Sunroof switch
NOTE: If can be determined whether the wiring harness Between the sunroof motor assembly and the ETACS-ECU is defective or not by checking the
SWS communication line.
CAUTION : To prevent damage to scan tool MB991502, always turn the ignition switch to the "LOCK" (OFF) position before connecting or
disconnecting scan tool MB991502.
1. Connect scan tool MB991502 to the data link connector.
2. Check that the tone alarm of scan tool MB991502 sounds when the input signal enters.
Q: Does the tone alarm of scan tool MB991502 sound when the input signal enters?
YES : Replace the sunroof motor assembly. The sunroof timer function should work normally.
NO:
