Sebring LX Coupe V6-3.0L VIN H (2002)
STEP 5. Check the seat belt warning light bulb.
Q: Is the seat belt warning light bulb in good condition?
YES : Go to Step 6.
NO : Replace it. The seat belt warning light should work normally.
STEP 6. Check the combination meter (printed-circuit board).
1. Remove the combination meter.
2. Remove the seat belt warning light bulb. Then measure the resistance between the bulb terminals.
3. Install the bulb to the combination meter, and then measure the resistance between connector C-102 terminal 27 and C-101 terminal 52. The
resistance reading at this time should be much the same as the resistance measured at Step (2).
Q: Are the two resistance values extremely different each other?
YES : Repair or replace the combination meter (printed circuit board). The seat belt warning light should work normally.
NO (much the same): Go to Step 7.
STEP 7. Check the ignition switch (IG1) circuit to the combination meter. Test at combination meter connector C-101.
1. Disconnect the combination meter connector C-101 and measure the voltage available at the wiring harness side of the connector.
2. Turn the ignition switch to the "ON" position.
3. Measure the voltage between C-101 terminal 52 and ground.
