Sebring LX Coupe V6-3.0L VIN H (2002)
2. Measure the voltage between terminal 5 and ground.
-
The voltage should equal approximately 12 volts (battery positive voltage).
Q: Is the measured voltage approximately 12 volts (battery positive voltage)?
YES : Replace the front-ECU. Check that the tail lights illuminate normally.
NO : Go to Go to Step 5.
STEP 5. Check the front-ECU connector A-10X for loose, corroded or damaged terminals, or terminals pushed back in the connector.
Q: Is front-ECU connector A-10X in good condition?
YES : Go to Step 6.
NO : Repair or replace the damaged component(s). Refer to Harness Connector Inspection. The taillights should illuminate normally.
STEP 6. Check the wiring harness between front-ECU connector A-1OX and battery.
Q: Is the wiring harness between front-ECU connector A-10X and battery in good condition?
YES : No action is necessary and testing is complete.
NO : The wiring harness may be damaged or the connector(s) may have loose, corroded or damaged terminals, or terminals pushed back in the
connector. Repair the wiring harness as necessary. The taillights should illuminate normally.
