Sebring LX Coupe V6-3.0L VIN H (2002)
EGR Valve: Testing and Inspection
1. Remove the EGR valve and inspect for sticking, carbon deposits, etc. If found, clean with a suitable solvent so that the valve seats correctly.
2. Connect a hand vacuum pump to the EGR valve.
3. Apply 67 kPa (20 in Hg) of vacuum, and check to be sure that the vacuum is maintained.
4. Apply a vacuum and check the passage of air by blowing through one side of the EGR passage.
NOTE: Passage of air should be checked by blowing the valve port.
5. Reinstall the EGR valve, using a new gasket, and tighten to the specified torque.
Tightening torque:
<2.4L ENGINE> 19 ± 3 N.m (14 ± 2 ft-lb)
<3.0L ENGINE> 22 ± 4 N.m (16 ± 3 ft-lb)
