Sebring LX Coupe V6-3.0L VIN H (2002)
>> A <<
SNAP RING REMOVAL
1. Set special tools MD998907 and MD998924 as shown in the illustration.
2. Compress the return spring and remove the snap ring.
>> A <<
D-RING INSTALLATION
1. Install a D-ring in the groove in the underdrive clutch retainer and piston, and in the groove in the outside of the spring retainer. Be careful not to
twist or damage the D-rings.
2. Apply ATF or petroleum jelly (Vaseline) to the D-rings.
>> B <<
SNAP RING INSTALLATION
1. Place the snap ring on top of the spring retainer, and then set special tool MD998907 as shown in the illustration.
2. Compress the return spring and install the snap ring.
>> C <<
CLUTCH PLATE/CLUTCH DISC/CLUTCH REACTION PLATE INSTALLATION
CAUTION: Immerse the clutch disc in ATF before assembling it. IF the clutch disc is new, soak it in ATF for at least two hours.
1. Assemble the four clutch plates and four clutch discs one on top of the other inside the underdrive clutch retainer. All four clutch plates should be
assembled so that the places with no teeth (marked "A") are aligned with the holes in the retainer (marked "B").
