Sebring LX Coupe V6-3.0L VIN H (2002)
Valve Body: Testing and Inspection
F4A51 - Automatic Transmission
SOLENOID VALVE CHECK
1. Use the scan tool to measure the ATF temperature and set the ATF temperature to 20°C (68°F).
2. Remove the A/T control solenoid valve assembly connector.
3. Measure the resistance between the solenoid valve terminals.
Standard Values
4. Check that the measured values are within the standard values at Steps 1 and 2.
5. If within the standard value, check the power supply and the ground circuits.
6. If not within the standard value, drain the ATF and remove the valve body cover.
7. Disconnect the connectors of each solenoid valve.
8. Measure the resistance between terminals 1 and 2 of each solenoid valve.
Standard value:...................2.7 - 3.4 Ohms [at 20°C (68°F)]
