Sebring LX Coupe V6-3.0L VIN H (2002)
CAUTION: Do not apply pressure to the wheel bearing by the vehicle weight to avoid possible damage when the driveshaft nut is loosened.
<< B >>
LOWER ARM BALL JOINT/TIE ROD END DISCONNECTION
CAUTION: Do not remove the nut from the ball joint. Loosen it and use special tool MB99111. or MB990635 to avoid possible damage to the ball
joint threads.
Hang special tools with rope or wire to prevent them from falling.
<< C >>
DRIVESHAFT/DRIVESHAFT AND INNER SHAFT REMOVAL
CAUTION: Do not damage the ABS rotor attached to the BJ outer race. <Vehicles with ABS>
1. Use special tools M13991354, MB990242 and MB990767 to push the driveshaft out from the hub.
CAUTION: Do not pull on the driveshaft; doing so will damage the TJ; be sure to use the pry bar.
Do not insert the pry bar so deep as to damage the oil seal.
Do not damage the transaxle oil seal with the spline of the driveshaft.
2. Insert a pry bar between the transaxle case and the driveshaft as shown to remove the driveshaft. <2.4L ENGINE, 3.01. ENGINE-LH>
CAUTION: Do not damage the transaxle oil seal with the spline of the inner shaft.
