Sebring LXI Convertible V6-2.7L VIN R (2002)
4.
Slightly pull the upper corner of the fascia outboard to provide access to the mounting holes. Using a die grinder or rat tail tile, elongate the fascia
to fender mounting holes and locating slots toward the front of the vehicle 4 mm (5/32 in.). (Fig. 2)
5.
Pull the rear corners of the fascia rearward until bottomed against the elongated slots and install the fascia to fender fasteners. Torque the fasteners
to 2 Nm (18 in. lbs.).
6.
Pull the top of the fascia forward until the rear portion of the elongated holes align with the holes in upper crossmember and install the fascia push
pin retainers.
POLICY:
Reimbursable within the provisions of the warranty.
TIME ALLOWANCE:
FAILURE CODE:
Technical Service Bulletin # 23-023-01
Date: 010831
Body - Fascia to Headlamp Gap
NUMBER: 23-023-01
GROUP: Body
