Sebring LXI Convertible V6-2.7L VIN R (2002)
10.
Inspect the two back foam-sealed attachment clips at the back of the trim panel. If they are damaged and need replacement, use p/n 06506853AA
only. Do not substitute a different attachment clip.
11.
Install the door trim panel, using the procedures outlined in the appropriate service manual or service information on MDS2.
12.
Repeat steps 1 - 11 to replace the door trim panel belt line molding on the other door trim panel.
13.
Clean any marks from the upper surfaces of the panels by wiping off with a mild liquid soap. Do NOT use any alcohol-containing products.
POLICY:
Reimbursable within the provisions of the warranty.
TIME ALLOWANCE
FAILURE CODE
Technical Service Bulletin # 23-024-02
Date: 020617
Audio System - Distorted Sound/Door Panel Buzzes/Rattles
NUMBER: 23-024-02
GROUP: Body
DATE: June 17, 2002
THIS BULLETIN IS BEING PROVIDED EN ADVANCE. DO NOT ORDER PARTS OR PERFORM ANY ACTIONS RELATED TO THIS
BULLETIN UNTIL JULY 1, 2002.
SUBJECT:
Distorted Audio System Bass Sound and/or Door Trim Panel Buzz/Rattle
OVERVIEW:
This bulletin involves installing two foam blocks, a screw, washer and tube behind the front door speaker grille, checking the torque on the door trim and
speaker fasteners, replacing the door pull cup screw as well as cutting a small hole in the water shield on both doors.
MODELS:
2001 - 2002 (JR) Sebring Convertible
SYMPTOM/CONDITION:
Distorted audio system bass sound and/or door trim panel buzz/rattle may be experienced during higher volume and bass output levels. This condition is
caused by loose door trim and/or speaker fasteners, and/or fluttering water shield and/or movement of the lower front corner of the door trim panel.
Audio system components, speakers in particular, have been found to have no causal effect for this condition and therefore speaker replacement should
be avoided.
DIAGNOSIS:
Play the audio system at a high volume and full bass setting, if a buzz/rattle noise is heard, perform the Repair Procedure.
