Sebring LXI Convertible V6-2.7L VIN R (2002)
Front Door Window Regulator: Procedures
REMOVAL- JR-27 ONLY
1. Remove door trim panel and water shield.
2. Disconnect wire connector to power window motor.
3. Remove nuts attaching regulator lift channel to door glass.
4. Secure door glass in upward position.
5. Mark position of rear bolt of roller channel to inner door panel to aid in installation.
6. Remove bolt attaching rear of roller channel to door panel.
7. Loosen bolt attaching front of roller channel to door panel.
Power Window Regulator
8. Remove roller channel from door panel.
9. Loosen bolts attaching window regulator to inner door panel reinforcement.
10. Remove bolt heads from key hole slots in inner door panel.
11. Remove window regulator through large hole in inner door panel.
12. Remove power window motor from regulator.
INSTALLATION - JR-27 ONLY
1. Install power window motor on regulator.
2. Move window regulator into position in door and engage bolt heads into key hole slots in inner door panel reinforcement and tighten bolts.
3. Install roller channel to door panel.
4. Install bolt at rear of roller channel. Make sure that bolt is aligned to mark on inner door panel made previously.
5. Tighten front and rear bolts of roller channel.
6. Install nuts attaching regulator lift channel to door glass.
7. Verify glass fit and operation. Adjust door glass, if necessary
8. Connect wire connector to power window motor.
9. Install door water dam and trim panel.
