Sebring LXI Convertible V6-2.7L VIN R (2002)
Convertible Top Weatherstrip: Service and Repair
Header / A - Pillar Weatherstrip
HEADER / A - PILLAR WEATHERSTRIP
REMOVAL
1. Partially raise convertible top.
2. Remove inside rear view mirror.
3. Remove sun visors.
4. Remove header trim panel.
5. Remove both door sill trim panels.
Fig. 12
6. Remove nuts holding header and A-pillar weatherstrip at upper corners of windshield (Fig. 12).
7. Remove push in fasteners at lower corners of windshield holding weatherstrip to A-pillar.
8. Remove header and A-pillar weatherstrip from vehicle.
9. Clean any residual seal material from header panel.
INSTALLATION
Fig. 13
CAUTION: Ensure that the butyl patch and butyl rope at each corner of the windshield is present and in good condition (Fig. 13). The butyl is
critical for the water management system. Replace as necessary.
