Sebring LXI Convertible V6-2.7L VIN R (2002)
Brake Fluid Level Sensor/Switch: Service and Repair
BRAKE FLUID LEVEL SWITCH
REMOVAL
1. Remove wiring harness connector from brake fluid reservoir level switch on the side of the reservoir.
2. Using a small screwdriver, release the retaining tabs on the opposite end of brake fluid level switch (on right side of reservoir) securing it to the
reservoir.
3. With retaining tabs compressed, grasp the connector end of brake fluid level switch and pull it out of master cylinder brake fluid reservoir.
INSTALLATION
1. Insert brake fluid level switch into left side of brake fluid reservoir. Be sure switch is pushed in until retaining tabs lock it to brake fluid reservoir.
2. Connect vehicle wiring harness connector to brake fluid level switch.
