Sebring LXI Convertible V6-2.7L VIN R (2002)
3. Before installing the ring compressor, make sure the oil ring expander ends are butted and the rail gaps located as shown in (Fig. 78).
4. Immerse the piston head and rings in clean engine oil, slide the ring compressor over the piston and tighten with the special wrench. Ensure
position of rings does not change during this operation.
CAUTION: Ensure the hole in bearing half aligns with hole in connecting rod, as damage to engine may occur.
5. Position bearing onto connecting rod. Ensure that hole in bearing half is aligned to hole in connecting rod. Lubricate bearing surface with clean
engine oil.
6. Install Special Tools 8189 Connecting Rod Guides into connecting rod (Fig. 70).
7. The pistons are marked on top with an arrow and with an "F" (Front) above the pin boss. These marks must be pointing toward the front of engine
on both cylinder banks. The connecting rod oil squirt hole faces the major thrust (right) side of the block (Fig. 72).
