Sebring LXI Convertible V6-2.7L VIN R (2002)
2. Install oil ring expander. Install the side rail by placing one end between the piston ring groove and the oil ring expander. Hold end firmly and
press down the portion to be installed until side rail is in position. Do not use a piston ring expander during this step (Fig. 76).
3. Install upper side rail first and then the lower side rail.
NOTE: The No. 1 and No. 2 piston rings have a different cross section. Ensure No. 2 ring is installed with manufacturers I.D. mark (dot) facing
up, towards top of the piston (Fig. 77)
4. Install No. 2 piston ring and then No. 1 piston ring (Fig. 78).
5. Position piston ring end gaps as shown in (Fig. 79).
6. Position oil ring expander gap at least 45° from the side rail gaps but not on the piston pin center or on the thrust direction. Staggering ring gap is
important for oil control.
