Sebring LXI Convertible V6-2.7L VIN R (2002)
3. Lock the doors with the power lock switch or the RKE.
4. Close the driver's door.
NOTE:
-
After the doors are closed, locking the doors with RKE will also arm the system
-
If the VTSS indicator lamp flashed, the system is operational and verified. If not, there may be a problem with the system.
Arming/Disarming - Active arming occurs when the remote keyless entry transmitter is used to lock the vehicle doors, whether the doors are open or
closed. If one or more doors are open the arming sequence is completed only after all doors are closed.
Passive disarming occurs upon normal vehicle entry (unlocking either front door with the key). This disarming also will halt the alarm once it has been
activated.
Active disarming occurs when the remote keyless entry transmitter is used to unlock the vehicle doors. This disarming also will halt the alarm once it has
been activated
NOTE: A Powertrain Control Module from a vehicle equipped with a vehicle theft security system cannot be used in a vehicle that is not equipped with
a vehicle theft security system. If the VTSS indicator lamp comes on after ignition ON and stays on, the PCI bus communication with the Power-train
Control Module possibly has been lost.
Wiper System
The wiper system provides the driver with the normal wiper (low and high speeds), intermittent wipe, and wipe after wash. The driver selects the wiper
function via the resistive multiplexed stalk switch mounted on the steering column. The BCM uses the input signal from the wiper stalk switch, wiper
motor park switch, and the washer switch to control the wiper system. The Body Control Module (BCM) then controls the relays and timing functions to
provide the driver selected features.
SYSTEM FEATURES
Speed Sensitive Intermittent Wipe Mode
There are 6 individual delay times with a minimum delay of 1/2 second to a maximum of 18 seconds. When the vehicle speed is under 10 MPH (6
KMH), the delay time is doubled providing a range of 1 second to 36 seconds.
Park after Ignition
Off Because the wiper relays are powered from the battery the BCM can run the wipers to park after the ignition is turned off.
Wipe after Wash
When the driver presses the wash button for over 1/2 second and then releases it, the wiper will continue to run for 2 additional wipe cycles.
The wiper system utilizes the BCM to control the on/off and hi/low relays fro low and hi speed wiper functions, intermittent wiper delay as the switch
position changes, pulse wipe, wipe after wash mode, and wiper motor park functions. The BCM uses the vehicle speed input to double the usual delay
time below 10 MPH (17 KMH).