Sebring LXI Convertible V6-2.7L VIN R (2002)
NOTE: Before replacing a catalytic converter, determine the root cause of failure. Most catalytic converter failures are caused by air, fuel or ignition
problems. (Refer to Appropriate Diagnostic Information) for test procedures.
INSTALLATION
1. Clean manifold to converter sealing surfaces.
2. Position new gasket on converter inlet flange.
3. Ensure exhaust manifold heat shield is in position, and loosely install converter with lower attaching bolt to exhaust manifold.
4. Lower vehicle.
5. Install 3 nuts attaching converter to manifold. Torque nuts to 28 Nm (250 inch lbs.).
6. Reconnect upstream oxygen sensor.
7. Raise vehicle.
8. Torque remaining attaching bolt to 28 Nm (250 inch lbs.).
9. Install cross-under pipe.
10. Lower vehicle.
11. Connect negative battery cable.
