Sebring LXI Convertible V6-2.7L VIN R (2002)
4. Install the three bolts fastening cast pump mounting bracket to engine. Tighten the bolts to a torque of 28 Nm (250 inch lbs.).
5. Loosely install bolt through the stamped adjuster bracket slot and into the cast bracket.
6. Using a lint free towel, wipe clean all open power steering hose ends, and power steering pump fittings.
7. Install power steering pump drive belt on power steering pump pulley.
8. Install a 1/2 inch breaker bar in the square adjusting hole in the front power steering pump mounting bracket and adjust the belt.
9. When correct drive belt tension is obtained, tighten the adjusting slot bolt to a torque of 28 Nm (250 inch lbs.).
10. Install a new O-ring on end of power steering pressure hose fitting. Lubricate all O-rings using fresh clean power steering fluid.
