Sebring LXI Convertible V6-2.7L VIN R (2002)
7. Install tie rod end into the steering knuckle. Start tie rod end to steering knuckle attaching nut onto stud of tie rod end. While holding stud of tie
rod end stationary, tighten tie rod end to steering knuckle attaching nut. Then using a crowfoot and socket tighten the attaching nut to a torque of
61 Nm (45 ft. lbs.).
8. Install brake rotor, and caliper, shoes and adapter assembly.
9. Clean all foreign matter from the threads of the outer C/V joint stub axle. Install hub nut onto driveshaft stub axle.
10. With vehicle brakes applied to keep braking disc from turning, tighten hub nut to 203 Nm (150 ft. lbs.) of torque.
11. Install front wheel and tire assembly. Install front wheel lug nuts and progressively tighten in crisscross sequence. Tighten to a torque of 135 Nm
(100 ft. lbs.).
12. Lower vehicle.
13. Set front toe on vehicle to required specification.
