Sebring LXI Sedan V6-2.7L VIN R (2002)
12. Road test the vehicle and make several stops to wear off any foreign material on the brakes and to seat the brake shoe linings.
Rear
REMOVAL - REAR DISC BRAKE CALIPER
1. Depress the brake pedal past its first inch of travel and hold it in this position using a brake pedal depressor (holding) tool. This is done to isolate
the master cylinder from the brake hydraulic system disallowing the brake fluid to completely drain out of the brake fluid reservoir.
2. Raise vehicle.
3. Remove rear wheel and tire from vehicle.
4. Remove the banjo bolt connecting the brake hose to the brake caliper. There are two washers (one on each side of the brake hose fitting) that will
come off with the banjo bolt. Discard these washers.
Caliper Assembly Guide Pin Bolts
5. Remove the 2 guide pin bolts mounting the caliper to the adapter.
Caliper Removal/Installation
6. Remove caliper from adapter and rotor by first rotating top of caliper away from the adapter, then lifting the caliper off lower machined abutment
on adapter.
INSTALLATION - REAR DISC BRAKE CALIPER
1. Completely retract caliper piston back into piston bore of caliper assembly.
2. Lubricate both adapter abutments with a liberal amount of Mopers Multipurpose Lubricant, or equivalent.
