Sebring LXI Sedan V6-2.7L VIN R (2002)
Hydraulic System Junction Block: Service and Repair
JUNCTION BLOCK
REMOVAL
Brake Pedal Holding Tool
1. Disconnect and isolate the negative battery connection at the left front strut tower.
2. Using a brake pedal holding tool such as shown, depress brake pedal past its first 1 inch of travel and secure in this position. This will isolate the
master cylinder reservoir from the brake hydraulic system, not allowing the brake fluid to drain out of the reservoir.
3. Remove the air cleaner housing.
4. Clean any debris away from the fittings on top of the junction block.
5. Remove the two brake tubes coming from the primary and secondary master cylinder ports at the junction block.
6. Remove the four chassis brake tubes going to each brake, mounted across the front top of the junction block .
