Sebring LXI Sedan V6-2.7L VIN R (2002)
15. Remove the park brake cable and sealing grommet from the floor pan of the vehicle.
INSTALLATION
For servicing of either the left or right rear parking brake cable, follow the procedure as listed below.
1. Install parking brake cable into floor pan of vehicle making sure sealing grommet is installed in floor pan as far as possible to insure a proper seal.
2. Install park brake cable into the rear brake adapter. Be sure locking tabs on cable retainer are expanded to ensure park brake cable is securely held
in the adapter.
NOTE: The park brake cable routing and routing clips are different on the right and left side of the vehicle. Be sure the correct routing clips are
installed on the correct side of the vehicle.
3. Attach the 2 park brake cable routing clips on the rear frame rail. Install and securely tighten routing clip attaching screws.
4. Install the park brake cable on the park brake shoe actuating lever.
5. Install the parking brake shoes, hub and bearing, rotor and caliper.
6. Install rear wheel and tire assembly on vehicle. Tighten all wheel lug nuts in crisscross pattern to one-half specified torque. Then repeat pattern,
fully tightening nuts to 135 Nm (100 ft. lbs.).
7. Lower vehicle.
8. Grasp park brake cable to floor pan seal grommet by hand, and pull it into floor pan to ensure seal grommet is fully seated into floor pan.
9. Route park brake cable under carpeting and up to park brake cable hole in console bracket on floor pan.
