Sebring LXI Sedan V6-2.7L VIN R (2002)
message length is only about 500 milliseconds, it is ineffective to try and measure the bus activity with a conventional voltmeter. The preferred method
is to use the DRBIII(R) lab scope. The 12 v square wave selection on the 20-volt scale provides a good view of the bus activity. Voltage on the bus
should pulse between zero and about seven and a half volts. Refer to the figure for some typical displays.
The PCI Bus failure modes are broken down into two categories. Complete PCI Bus Communication Failure and individual module no response. Causes
of a complete PCI Bus Communication Failure include a short to ground or battery on the PCI circuit. Individual module no response can be caused by
an open circuit at the BCM or at the module, or an open battery or ground circuit to the affected module.
Symptoms of a complete PCI Bus Communication Failure would include but are not limited to:
-
All gauges on the MIC stay at zero
-
All telltales on MIC illuminate
-
MIC backlighting at full intensity
-
No response received from any module on the PCI bus (except PCM)
-
No start (if equipped with Sentry Key Immobilizer)
Symptoms of Individual module failure could include any one or more of the above. The difference would be that at least one or more modules would
respond to the DRBIII(R).
Diagnosis starts with symptom identification. If a complete PCI Bus Communication Failure is suspected, begin by identifying which modules the
vehicle is equipped with and then attempt to get a response from the modules with the DRBIII(R). If any modules are responding, the failure is not
related to the total bus, but can be caused by one or more modules PCI circuit or power supply and ground circuits. The DRBIII(R) may display "BUS to
SIGNALS OPEN" OR "NO RESPONSE" to indicate a communication problem. These same messages will be displayed if the vehicle is not equipped
with that particular module. The CCD error message is a default message used by the DRBIII(R) and in no way indicates whether or not the PCI bus is
operational. The message is only an indication that a module is either not responding or the vehicle is not equipped.
NOTE: Communication over the bus is essential to the proper operation of the vehicles on-board diagnostic systems and the DRBIII(R). Problems with
the operation of the bus or DRBIII(R) must be corrected before proceeding with diagnostic testing. If there is a problem, refer to the Communications
category.
BUS FAILURE MESSAGE
Odometer Displays "No Bus" - The Mechanical Instrument Cluster (MIC) cannot communicate over the bus and does not know why.
Vehicle Theft Security System
