Sebring LXI Sedan V6-2.7L VIN R (2002)
Body Control Module: Description and Operation
System Description
IDENTIFICATION OF SYSTEM
The vehicle systems that are part of the "body" system are:
-
Airbag System
-
Audio
-
Chimes
-
Compass/Mini-Trip
-
Door Ajar
-
Exterior Lighting
-
Heating and A/C
-
Interior Lighting
-
Mechanical Instrument Cluster
-
Power Door Locks/Remote Keyless Entry
-
Power Convertible Top
-
Vehicle Communications
-
Vehicle Theft Security System
-
Wiper/Washer
SYSTEM DESCRIPTION AND FUNCTIONAL OPERATION
The body system on the 2002 JR consists of a combination of modules that communicate over the PCI bus (Programmable Communication Interface
multiplex system). Through the PCI bus, information about the operation of vehicle components and circuits is relayed quickly to the appropriate
modules. All modules receive all the information transmitted on the bus even though a module may not require all information to perform its function. It
will only respond to messages "addressed" to it through a binary coding process. This method of data transmission significantly reduces the complexity
of the wiring in the vehicle and the size of wiring harnesses. All of the information about the functioning of all the systems is organized, controlled and
communicated by the PCI bus, which is described in the Vehicle Communication section of this General Information.
Always begin by reading the diagnostic trouble codes using the DRBIII(R). Next, look for the symptom in the Diagnostic Information and Procedures
section of the Table of Contents located in the front of the book. This will direct you to the specific tests that must be performed.
IMPORTANT NOTE: If the Powertrain Control Module has been changed and the correct VIN and mileage have not been programmed, a DTC will
be set in the Airbag module. In addition, if the vehicle is equipped with a Sentry Key Immobilizer Module (SKIM), Secret Key data must be updated to
enable starting. Erase codes in all modules.
