Sebring LXI Sedan V6-2.7L VIN R (2002)
Fig.9 Test Battery Positive Connection Resistance - Typical
2. Connect the positive lead of the voltmeter to the battery positive terminal post. Connect the negative lead of the voltmeter to the battery positive
cable terminal clamp (Fig. 9). Rotate and hold the ignition switch in the Start position. Observe the voltmeter. If voltage is detected, correct the
poor connection between the battery positive cable terminal clamp and the battery positive terminal post.
Fig.10 Test Battery Positive Cable Resistance - Typical
3. Connect the voltmeter to measure between the battery positive cable terminal clamp and the starter solenoid B(+) terminal stud (Fig. 10). Rotate
and hold the ignition switch in the Start position. Observe the voltmeter. If the reading is above 0.2 volt, clean and tighten the battery positive
cable eyelet terminal connection at the starter solenoid B(+) terminal stud. Repeat the test. If the reading is still above 0.2 volt, replace the faulty
battery positive cable.
