Sebring LXI Sedan V6-2.7L VIN R (2002)
11. Install the power steering pressure hose on the power steering pump pressure fitting. Tighten the tube nut to a torque of 31 Nm (275 inch lbs.).
12. Install accessory drive splash shield.
13. Lower vehicle.
14. Install power steering fluid supply hose on power steering pump supply fitting. Install hose clamp on hose. Be sure hose clamp is installed on hose
past upset bead on power steering fluid reservoir.
15. Connect battery cable back on negative (-) post of battery.
16. Fill power steering reservoir to correct fluid level and perform Power Steering Pump Initial Operation standard procedure.
17. Check for leaks at all hose connections and power steering pump.
