Sebring LXI Sedan V6-2.7L VIN R (2002)
4. Install the rear stabilizer bar attaching link, isolator bushings and attaching nut on the forward lateral link. Tighten the attaching nut to a torque of
35 Nm (26 ft. lbs.).
5. Install wheel and tire assembly on vehicle. Progressively tighten the wheel mounting nuts in crisscross sequence until all nuts are torqued to half
specification. Then repeat the tightening sequence to the full specified torque of 135 Nm (100 ft. lbs.).
6. Lower vehicle to the ground.
7. Check and reset rear wheel Camber and Toe to specifications if required.
REAR LATERAL LINK
1. Install the lateral link and the attaching nut and bolt at rear suspension crossmember. The rear lateral link is to be installed with the adjusting screw
toward rear suspension crossmember, not rear knuckle.
2. Install the lateral link and the attaching nut, bolt and washer at rear knuckle.
3. Torque both lateral link attaching bolts to 108 Nm (80 ft. lbs.).
4. Install wheel and tire assembly on vehicle. Progressively tighten the wheel mounting nuts in crisscross sequence until all nuts are torqued to half
specification. Then repeat the tightening sequence to the full specified torque of 135 Nm (100 ft. lbs.).
5. Lower vehicle.
6. Check and reset rear wheel Camber and Toe to specifications if required.
