Sebring Sedan L4-2.4L (2007)
1. Disconnect and isolate the battery negative remote cable.
2. Using a trim stick special tool #C-4755 or equivalent, gently pry out on the edge of the console bezel (1) and pull outward.
3. Disconnect wire connectors (2) from behind console bezel.
4. Remove the console bezel (1) from the vehicle.
Installation
INSTALLATION
The HVAC control is mounted to the console bezel. If replacing the console bezel or the HVAC control, it must be removed from the console bezel.
Remove the six retaining screws to the HVAC control.
1. Connect the wire connectors (2) to the HVAC control.
2. Position the console bezel (1) over the retaining slots and firmly snap the console bezel (1) into place.
3. Connect the battery negative remote cable.
Removal
REMOVAL
NOTE: Chrysler shown, Dodge similar.
