Sebring Sedan L4-2.4L (2007)
4. Install the four chassis brake tubes (2, 3, 5, 6) brake tubes at the ICU hydraulic control unit (7). Tighten the tube nuts to 17 Nm (150 in. lbs.).
5. Install the primary (4) and secondary (1) brake tubes at the ICU hydraulic control unit (7). Tighten the tube nuts to 17 Nm (150 in. lbs.).
6. Push the brake tube bundle routing clips (with tubes) onto the studs on the dash panel.
7. Install the heat shield on the dash panel and tighten the lower and upper mounting nuts.
8. Remove the brake pedal holding tool.
9. Install the engine appearance cover.
10. Connect the battery negative cable to the battery post. It is important that this be performed properly.
