Sebring Sedan L4-2.4L (2007)
4. Remove the banjo bolt (4) connecting the brake flex hose (2) to the brake caliper (5). There are two washers (3) that will come off with the banjo
bolt. Discard the washers.
NOTE: When removing the caliper guide pin bolts (2, 3) note that one (upper) has a special sleeve on the end. It is important that this bolt
be installed in the upper mounting hole when the caliper is installed.
5. Remove the two brake caliper guide pin bolts (2, 3).
6. Slide the disc brake caliper (4) from the disc brake adapter bracket (1) and brake pads and remove.
Installation
INSTALLATION
1. Completely retract the caliper piston back into the bore of the caliper. Use a C-clamp to retract the piston. Place a wood block over the piston
before installing the C-clamp to avoid damaging the piston.
