Sebring Sedan L4-2.4L (2007)
CAUTION: When removing the caliper guide pin bolts (2, 3) note that one has a special sleeve on the end. It is important that this bolt (3)
be installed in the upper mounting hole when the caliper is installed.
7. Remove the two brake caliper guide pin bolts (2, 3).
8. Slide and remove the disc brake caliper (1) with outboard brake pad attached from the disc brake adapter bracket, inboard brake pad and rotor.
9. Remove the outboard brake pad from the caliper by prying the brake pad retaining clip over the raised area on the caliper. Slide the brake pad off
of the brake caliper.
Installation
INSTALLATION
1. If not already performed, completely retract the caliper piston back into the piston bore of the caliper. Use a C-clamp to retract the piston. Place a
wood block over the piston before installing the C-clamp to avoid damaging the piston.
2. Slide the outboard brake pad onto the caliper. Be sure the retaining clip is squarely seated in the depressed areas on the caliper beyond the raised
retaining bead.
CAUTION: Use care when installing the caliper onto the disc brake adapter to avoid damaging the guide pin boots.
3. Install the disc brake caliper with outboard brake pad attached over the inboard brake pad and rotor, onto the brake caliper adapter bracket.
