Sebring Sedan L4-2.4L (2007)
CAUTION: When installing a master cylinder on the vehicle, a NEW vacuum O-ring seal (2) MUST be installed on the master cylinder
mounting flange (1).
4. If the master cylinder does not have a new vacuum O-ring seal (2) on the mounting flange (1), remove it. Install a NEW vacuum O-ring seal on the
master cylinder mounting flange making sure the O-ring fits evenly against the mounting flange.
CAUTION: If resistance is met during master cylinder insertion into power brake booster, the master cylinder push rod may not be lined
up with the booster push rod. Remove the master cylinder, realign and insert it again.
5. Line the master cylinder mounting holes up with the mounting studs on the power brake booster. Ensure the master cylinder piston push rod lines
up with the booster push rod, then carefully slide the master cylinder into the power brake booster until it contacts the face of the booster.
6. Install two NEW master cylinder mounting nuts (3). Tighten each nut to 25 Nm (18 ft. lbs.).
