Sebring Sedan L4-2.4L (2007)
NOTE: If the crankshaft is sent out for machine work, it must be balanced as an assembly with the target ring installed.
4. Clean crankshaft and target ring with MOPAR(R) Brake Parts cleaner and dry with compressed air to ensure that the crankshaft mating surface and
target ring mounting holes are free from oil and lock patch debris.
NOTE: Always use NEW mounting screws whether installing original or new target ring.
5. Install NEW mounting screws finger tight starting with the #1 location. Make sure engagement occurs with the shoulder of the screws and
mounting hole before starting all other screws.
6. Tighten all mounting screws to 13 Nm (110 in-lbs) in the sequence shown.
NOTE: Lightly apply trans gel to thrust bearings to hold bearings in block.
NOTE: The thrust bearings must be installed the notches facing the crankshaft.
7. Install thrust bearings (2) in block (1).
CAUTION: Do not get oil on the ladder frame mating surface. It will affect the ability of the RTV to seal the ladder frame to cylinder