Sebring Sedan L4-2.4L (2007)
2. Position bottom of drive belt on the bottom of the power steering pulley.
NOTE: Use only wire ties with nylon locks, not metal.
3. Working from the back side of the power steering pulley, insert a nylon wire tie, 7.75X1/8x.50 in., through one of the holes in the pulley.
4. Tighten the wire tie to hold the drive belt in position.
5. While holding the drive belt to make sure it stays in position, slowly rotate the engine clockwise.
6. Once the belt is in position on the pulley, continue rotating the engine until the wire tie snaps.
7. Remove the wire tie from the vehicle.
8. Install RF inner wheel splash shield.
