Sebring Sedan L4-2.4L (2007)
NOTE: LHD Chrysler model shown. Dodge and RHD models similar.
1. Position the defroster duct (1) to the instrument panel top cover (2) and engage the duct to the cover.
2. Install the three screws (3) that secure the defroster duct to the instrument panel top cover. Tighten the screws to 2.2 Nm (20 in. lbs.).
3. Install the demister ducts.
4. Install the instrument panel top pad.
5. Install the outer instrument panel ducts.
6. Install the left and right instrument panel air outlets.
7. Install the instrument panel.
Removal
REMOVAL
WARNING: Disable the airbag system before attempting any steering wheel, steering column, or instrument panel component diagnosis or
service. Disconnect and isolate the battery negative (ground) cable, then wait two minutes for the airbag system capacitor to discharge before
performing further diagnosis or service. This is the only sure way to disable the airbag system. Failure to take the proper precautions could
result in an accidental airbag deployment and possible personal injury or death.
NOTE: LHD Chrysler model shown in illustrations. Dodge and RHD models similar.
RIGHT FRONT FLOOR DUCT
