Sebring Sedan L4-2.4L (2007)
NOTE: Right side rear floor duct shown. Left side duct similar.
10. Connect the rear seat floor duct (2) to the rear floor distribution duct (3). Make sure the ducts are fully engaged to each other.
11. Engage the retainer that secures the rear seat floor duct to the floor support (4) and install the retaining screw (1). Tighten the screw to 2.2 Nm (20
in. lbs.).
12. Reinstall the carpet.
13. Install the front seat to the side of the vehicle being serviced.
14. Install the center floor console.
Removal
REMOVAL
WARNING: Disable the airbag system before attempting any steering wheel, steering column, or instrument panel component diagnosis or
service. Disconnect and isolate the negative battery (ground) cable, then wait two minutes for the airbag system capacitor to discharge before
performing further diagnosis or service. This is the only sure way to disable the airbag system. Failure to take the proper precautions could
result in accidental airbag deployment and possible personal injury or death.
NOTE: Take the proper precautions to protect the front face of the instrument panel from cosmetic damage while performing this procedure.
NOTE: LHD Chrysler model shown in illustrations. Dodge and RHD models similar.
OUTER DUCTS
