Sebring Sedan L4-2.4L (2007)
6. Adjust air pressure to that listed on Tire Inflation Pressure Label (Placard) provided with vehicle (applied to driver's side B-pillar). Make sure
original style and color valve stem cap is securely installed to keep moisture out of sensor.
7. Install tire and wheel assembly (1) on vehicle. Tighten wheel mounting nuts (3) to 135 Nm (100 ft. lbs.).
8. Lower vehicle.
9. Perform one of the following to make the system learn the new sensor ID.
a. Use the TPM-RKE Analyzer, Special Tool 9936, with the Scan Tool to program the WCM/SKREEM with the tire pressure sensor ID. This is
part of the TPM Diagnostic Verification Test.
b. Once the vehicle has remained stationary for more than 20 minutes, drive vehicle for a minimum of 10 minutes while maintaining a continuous
speed above 15 mph (24 km/h). During this time, the system will learn the new sensor ID. This is part of the TPM Diagnostic Verification
Test.
NOTE: If a sensor cannot be trained, refer to appropriate diagnostic information.
