Sebring Sedan L4-2.4L (2007)
Engine Control Module: Testing and Inspection
PCM/ECM/SKREEM PROGRAMMING
NOTE: Before replacing the Powertrain Control Module (PCM) or Engine Control Module (ECM), be certain to check the related component/circuit
integrity for failures not detected due to a double fault in the circuit. Most PCM/ECM driver/control circuit failures are caused by internal component
failures (i.e. relays and solenoids) and shorted circuits (i.e. pull-ups, drivers, and switched circuits). These failures are difficult to detect when a double
fault has occurred and only one DTC has been set.
When a PCM, or ECM, and the Sentry Key REmote Entry Module (SKREEM) on vehicles equipped with the Sentry Key Immobilizer System (SKIS)
are replaced at the same time, perform the following steps in order:
1. Program the new PCM or ECM.
2. Program the new SKREEM (also sometimes referred to as the Wireless Control Module or WCM).
3. Replace all ignition keys and program them into the new SKREEM/WCM.
PROGRAMMING THE SKREEM
The SKIS Secret Key is an ID code that is unique to each SKREEM/WCM. This code is programmed and stored in the SKREEM/WCM, the
PCM/ECM, and each ignition key transponder chip. When the PCM or SKREEM/WCM is replaced, it is necessary to program the Secret Key into the
new module using a diagnostic scan tool. Follow the programming steps outlined in the diagnostic scan tool for "PCM Replaced" or "WCM Replaced"
under "Miscellaneous Functions" for the "WCM/Wireless Control Module" menu item as appropriate.
NOTE: If the PCM/ECM and the SKREEM/WCM are replaced at the same time, all vehicle ignition keys will need to be replaced and new keys
programmed into the new SKREEM/WCM.
NOTE: Programming the PCM/ECM or SKREEM is done using a diagnostic scan tool and a PIN to enter secure access mode. If eight attempts are
made to enter secure access mode using an incorrect PIN, secure access mode will be locked out for one hour. To exit this lockout mode, turn the
ignition to the RUN position for one hour then enter the correct PIN. (Ensure all accessories are turned OFF. Also monitor the battery state and connect
a battery charger if necessary).
PROGRAMMING IGNITION KEYS TO THE SKREEM
Each ignition key transponder also has a unique ID code that is assigned at the time the key is manufactured. When a key is programmed into the
SKREEM/WCM, the transponder ID code is learned by the module and the transponder acquires the unique Secret Key ID code from the
SKREEM/WCM. To program ignition keys into the SKREEM/WCM, follow the programming steps outlined in the diagnostic scan tool for
PROGRAM IGNITION KEYS OR KEY FOBS under MISCELLANEOUS FUNCTIONS for the WCM/WIRELESS CONTROL MODULE
menu item.
NOTE: A maximum of eight keys can be learned to each SKREEM. Once a key is learned to a SKREEM, that key has acquired the Secret Key for that
SKREEM and cannot be transferred to any other SKREEM or vehicle.
If ignition key programming is unsuccessful, the scan tool will display one of the following error messages:
-
Programming Not Attempted - The scan tool attempts to read the programmed key status and there are no keys programmed into SKREEM
memory.
-
Programming Key Failed (Possible Used Key From Wrong Vehicle) - SKREEM is unable to program an ignition key transponder due to one
of the following:
-
The ignition key transponder is faulty.
-
The ignition key transponder is or has been already programmed to another vehicle.
-
8 Keys Already Learned, Programming Not Done - The SKREEM transponder ID memory is full.
-
Learned Key In Ignition - The ID for the ignition key transponder currently in the ignition lock cylinder is already programmed into SKREEM
memory.
