Sebring Sedan L4-2.4L (2007)
Engine Control Module: Removal and Replacement
Removal
REMOVAL
The PCM must be program after it has been replaced.
To avoid possible voltage spike damage to PCM, ignition key must be off, and the negative battery cable must be disconnected before unplugging the
PCM connectors. Note radio programs.
1. Remove the air induction hose.
2. Remove the Air Cleaner Housing.
3. Disconnect the negative battery cable and isolate.
WARNING: If the negative battery cable is not disconnected there's a possibility of damaging the Powertrain Control Module by
contacting the Positive battery cable at the PDC.
4. Unlock and disconnect the electrical connectors at the PCM.
