chrysler Workshop Repair Guides

Chrysler Workshop Service and Repair Manuals

Engine Controls - MIL ON/DTC's P0128/P2181|Page 5865 > < Engine Controls - Underhood Ticking Noise|Page 5860
Page 1
background image

PROM - Programmable Read Only Memory: All Technical Service Bulletins
Engine Controls - MIL ON/DTC's P0128/P2181

NUMBER: 18-017-07

GROUP: Vehicle Performance

DATE: March 2, 2007

THE StarSCAN(R) FLASH FILES FOR THIS BULLETIN MUST BE RETRIEVED FROM THE INTERNET.

StarSCAN(R) SOFTWARE LEVEL MUST BE AT RELEASE 7.03 OR HIGHER FOR THIS BULLETIN.

SUBJECT:
Flash: MIL Illumination with DTC's P0128 or P2181

OVERVIEW:
This bulletin involves selectively erasing and reprogramming the Powertrain Control Module (PCM) with new software.

MODELS:

2007

(JS)

Sebring

2008

(JS)

Avenger

NOTE:

This bulletin applies to models equipped with a 2.0L or 2.4L engine (Sales Codes ECN or ED3) built prior to March 5, 2007 (MDH 0305XX).

SYMPTOM/CONDITION:
Some vehicle operators may experience MIL illumination after a cold start with long idle time, (greater than 20 minutes). This is usually accompanied
with minimal accessory loads. No other symptoms will be experienced.

The technician may find the following DTC's:

^

P0128-Thermostat Rationality

^

P2181-Cooling System Performance

The DTC's may be intermittent and may be difficult to duplicate.

DIAGNOSIS:

Using a Scan Tool (StarSCAN(R)) with the appropriate Diagnostic Procedures available in TechCONNECT, verify all engine systems are functioning as
designed. If DTC's other than those listed above are present record them on the repair order and repair as necessary before proceeding further with this
bulletin.

If MIL illumination with DTC P0128 or P2181 is present, perform the Repair Procedure.

PARTS REQUIRED:

Engine Controls - MIL ON/DTC's P0128/P2181|Page 5865 > < Engine Controls - Underhood Ticking Noise|Page 5860