Sebring Sedan L4-2.4L (2007)
4. Remove the center rear seat belt retractor assembly from the vehicle.
Installation
INSTALLATION
WARNING: Inspect the condition of the shoulder/lap belt. Replace the retractor if the belt is cut, frayed, torn, or damaged in any way. Failure
to inspect the belts could result in improper restraint and could cause occupant serious or fatal injury.
1. Route webbing and bezel through rear shelf trim panel.
2. Install the seat belt anchor and buckle (4) onto the stud.
3. Install nut and tighten to 101 Nm (74.5 ft. lbs.).
4. Install the center rear seat belt retractor assembly on the rear shelf. Tighten the bolt to 52 Nm (38.5 ft. lbs.).
